Honeywell Home RDWL313A2000 Guide D'installation Et D'utilisation page 4

Install Doorbell
If you are not mounting the doorbell to the wall, place it where you want it.
1. Screw the doorbell wall mounting bracket
to the wall using the included screws and
anchors (if necessary).
Drill 1/4 inch holes for the anchors.
Install Push Button
1. Mount the push button
bracket in the desired
location.
Use the screws
–OR–
Use the adhesive backing. If
using the adhesive backing,
clean the surface first.
2. Snap the push button onto
the mounting bracket.
Note: If you need to remove the push button, use a small
screwdriver to release the tab.
33-00183EFS_A.indd 4
2. Hang the doorbell on the
mounting bracket.
–OR–
4
4/15/2016 3:20:22 PM