Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MN6105VAV 5 NM VAV ACTUATOR
Panel Mounting
The controller enclosure is constructed of a plastic base
plate and a plastic factory-snap-on cover.
NOTE: The controller is designed so that the cover does
not need to be removed from the base plate for
either mounting or wiring.
By using this Honeywell literature, you agree that Honeywell will have no liability for any damages arising out of your use or
modification to, the literature. You will defend and indemnify Honeywell, its affiliates and subsidiaries, from and against any
liability, cost, or damages, including attorneys' fees, arising out of, or resulting from, any modification to the literature by you.
Home and Building Technologies
In the U.S.:
Honeywell
715 Peachtree Street NE
Atlanta, GA 30308
customer.honeywell.com
The controller mounts using four screws inserted through
the corners of the base plate. Fasten securely with four No.
6 or No. 8 machine or sheet metal screws.
The controller can be mounted in any orientation.
Ventilation openings are designed into the cover to allow
proper heat dissipation, regardless of the mounting
orientation.
® U.S. Registered Trademark
© 2018 Honeywell International Inc.
31-00150EF—03 M.S. Rev. 07-18
Printed in United States
Publicité
Table des Matières
