Accessoires - ALPATEC ALPACLIM AC 9004 E Mode D'emploi

notice AC 9004 E/ET/CTC 10/12/04 16:30
DESCRIPTION DE L
DESCRIPTION DE L
Tableau de contrôle
Poignée de
Grilles
transport
horizontales
Réservoir
d'eau
Roulettes
Cordon
électrique
VUE DE FACE

ACCESSOIRES

ACCESSOIRES
DESSIN DES PIECES NOM DES PIECES
Gaine
Manchon A (pour le montage permanent de la gaine)
Buse de sortie d'air B (pour le montage provisoire de la gaine)
Chevilles
Vis
• Vérifier que tous les accessoires sont bien dans l'emballage. • Se référer au mode d'emploi pour leur utilisation.
INST INST
1• I :
MPORTANT
Installer le climatiseur sur une surface plane et
dans un endroit spacieux, où les orifices de
ventilation ne seront pas bouchés.
Laisser un espace minimum de 30 cm entre le
climatiseur et le mur ou tout autre objet.
La prise de l'appareil doit toujours être accessible
après son installation.
Page 7
'APP AREIL
'APP AREIL
Orifices de
ventilation
Support du
filtre
VUE ARRIÈRE VUE DE CÔTÉ
QUANTITE
1
1
1
4
4
ALLA ALLA TION TION
4
3• DEHUMIDIFYING OPERATION.
- Press the "MODE" button several times until the operating panel window displays "DRY".
- The fan will run at a fixed speed at this setting.
- Keep windows and doors closed for the best dehumidifying effect. Do not put the duct to window.
4• HEATING OPERATION .
Press the "MODE" button several times until the operating panel window displays "HEAT".
Press the "TIMER " or "TIMER " button to select your desired romm temperature (16°C to 32°C).
Press the "FAN" button to choose the fan speed.
5. FAN OPERATION.
- Press the "MODE" button several times until the operating panel window displays "FAN".
- Press the "FAN" knob to choose the fan speed (low, middle, high).
6• TIMER OPERATION.
- Press the "TIMER " or "TIMER " knob when the air conditioner is off to select the time you need the unit
starts to operate or stops. The range of setting time is 0 and 24 hours. The unit will start and stop automatically.
Press "CLOCK" button when completed. The operation panel window will display "TIMER ON" if you selected the
unit start or "TIMER OFF" if you selected the unit stop.
7• AUTOMATIC LOUVER.
- Press the "SWING" button and the louver button will automatically move to control direction of airflow.
- To stop the movement of louver, press the "SWING" button again.
8• DRAIN TANK INDICATOR.
- When the drain tank is full the "WATER FULL" indicator will blink. The dry
process stops immediately. The fan process continue to operate.
Take out the tank carefully to avoid water splashing and empty the drain tank.
Put the tank back to place properly. Wait 3 minutes before the compressor
starts again. The dry process will automatically resume.
9• CONTINUOUS DRAINAGE.
- Drain water can be collected externally by directing the plastic tube inside the
drain tank cabin through the water tank to any vessel such as bucket. Remove
the plastic tube cap before operating.
- Do not take out the water tank during drainage.
21