Flex BME 18.0-EC + LK 152 Notice D'instruction D'origine page 34

Open the clamping lever on the attach -

ment (1.).
Press and hold down the release lever (2.).

Lift the drive unit off the attachment (3.).

Loosen the locking screw on the attach -

ment (1.).
Push and hold the release lever (2.).

Lift off the attachment (3.).

Burnishing attachment BS 50
Securing the tool
The tool holder enables the tool to be
changed without any tools.
34
TRINOXFLEX BME 18.0-EC + LK 152 / + BR 50 / + BF 140 / + BS 50
Remove the battery.

Press and hold the spindle lock (1.).

Push the tool or tool carrier on the tool

holder (tongue and groove fitting) (2.).
Press the tool downwards against spring

pressure (3.) and turn clockwise (4.).
The tool holder is locked.
NOTE
The width of the tool holder is 50 mm.
Depending on the tool width, several tools
may need to be fitted or the differences in
width compensated for by means of spacer
rings.
Examples:
Polishing wheel,
50 mm wide:
Polishing mop, 10 mm
wide:
Switch on the power tool (without detent)

and allow it to run for approx. 30 seconds.
Check for imbalance and vibrations.
Switch off the power tool.

Using the parallel guide
The parallel guide ensures exact straight
running when machining profiles.
1 tool
4 tools and
spacer rings