Publicité
Les langues disponibles
Les langues disponibles
Installation*
DO NOT connect the Ethernet Adapter to the computer before completing the driver installation.
Windows OS:
Insert the Driver CD into your disk drive. Locate and double click <Setup.exe> to launch the
setup procedure. Click <Next> to continue, then click <Finish> to complete the installation.
Mac OS:
Insert the provided CD into your disk drive. Locate and double click <AX88179...pkg> to launch
the setup procedure.
Verifying the driver
Follow the steps below to open the Device Manager on Windows:
Windows 7: Control Panel\System and Security\System\Device Manager
Windows XP: Control Panel\System\Hardware\Device Manager
In the Network adapters group, an item named ASIX....Ethernet Adapter should be listed.
Follow the steps below to open the Device Manager on Mac OS:
1. Connect the USB to Ethernet adapter to the Mac.
2. Click the System Preferences -> Network -> USB Gigabit Ethernet device active on line
Note: If there appears a question or exclamation mark, the driver is not properly installed.
Please delete the item then, unplug the adapter and repeat the installation.
Connection:
Connect the adapter to an available network when the installation procedure is completed.
1. Connect an Ethernet cable to the Ethernet port of the adapter, then connect the other
end of the Ethernet cable to an available network hub, switch or router.
2. Plug the USB connector of the adapter into a free USB port of the computer. A pop-up
message will appear in the notification area, indicating that the installation is completed.
Note: The Link LED should light up in yellow to indicate a proper physical connection between
adapter and network. If the Link LED does not light up, please verify the cable connection
between all the network devices.
* The description of the driver installation shown here is an example. The actual strings and screen shots
may vary slightly on each operating system.
All manuals and user guides at all-guides.com
User Guide
Publicité
