Westinghouse WST5000ZE Manuel Du Propriétaire page 8

Table des Matières

Publicité

OPERATING INSTRUCTIONS
STEAM IRONING
When using as a Steam Iron, be sure the temperature setting on the
Temperature Control Dial is within the WOOL to LINEN setting to avoid
water spotting on the garment.
1. Before first use, remove any adhesive stickers from the Soleplate.
Make sure all adhesive is removed by rubbing Soleplate with a
damp cloth.
2. Turn Steam Dial to "OFF".
This will stop the flow of
steam if water is in the Reservoir.
3. Turn Temperature Dial to "MIN".
4. With the unit UNPLUGGED, lift Water Fill Port Cover and pour water
through Water Fill Port to the "MAX" water level.
CAUTION: Never fill Iron with fabric conditioner, starches, or
any other solution as these will damage the steam mecha-
nism. Do not use contaminated water.
5. Plug the cord into a 120V AC electrical outlet.
6. Turn Temperature Dial to "WOOL", "COTTON" or "LINEN" setting.
(If the temperature is set below these temperatures, steam will not be
able to form properly and water may drip from the Soleplate.)
The Red Indicator Light will turn on as soon as the Iron receives
power and the Temperature Dial is turned to a heat setting above
"MIN".
NOTE: When turned on for the first time, your new Iron may emit an
odor for up to 10 minutes. This is due to the initial heating of the mate-
rials used in making the Iron. The odor is safe and should not reoccur
after initial heating.
7. Turn Steam Dial to adjust steam rate. When using the maximum
steam rate, the iron uses more water and it may be necessary to fill
the Reservoir more often.
8. Place Iron on its Heel Rest and place on a stable, protected surface.
Allow Iron to heat to selected temperature setting. When Red
Indicator Light turns off, the Iron is ready for use.
9. When finished ironing, turn Temperature Dial to "MIN" and Steam
Dial to "OFF". Unplug Iron from wall outlet. Allow Iron to cool com-
pletely before cleaning the exterior of the Iron or storing.
CAUTION: Avoid coming in contact with escaping steam.
CAUTION: If the Iron has not been used for a long period of time and
is hot, DO NOT fill it with water. Allow to cool, then refill and resume
ironing.
(Cont.)
8
(Cont.)

Publicité

Table des Matières
loading

Table des Matières