Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. Lower vehicle exhaust – Using the exhaust removal pliers, lower muffler by removing (2) rubber hangers, (1) on each end of muffler. Using pliers, bend heat shield
on passenger side closest to end panel. Note: Be sure that exhaust is supported before removing rubber hangers. A spray lubricant or soapy water on rubber
hangers make them slide off metal pins more easily.
©2020 Horizon Global Americas Inc. - Printed in Mexico
Sheet 5 of 27
24992NP
2-14-20
Rev. A
Publicité
Table des Matières
