Kinderkraft MINIBI Mode D'emploi page 12

We design our bicycles with your child in mind - we always care about safety and quality, which guarantees that with
the purchase of our products you get the comfort of the best possible choice.
IT IS IMPORTANT TO KEEP THIS MANUAL FOR FUTURE USE.
SAFETY INSTRUCTIONS AND PRECAUTIONS
Attention:
● Compliance with the user manual ensures safe use of the toy. Read the user manual carefully before using the bike
and keep it for future use. Recommended age: 1+.
● Use personal protective equipment such as helmets, gloves, elbow pads and knee pads. This product is intended for
outdoor use. Do not use in road traffic. The kids cruiser bike should not be used near motor vehicles, streets,
swimming pools, hills, roads, stairs or on uneven ground.
● Use the toy on flat, obstacle-free surfaces.
● To avoid serious injuries, continuous adult supervision is necessary.
● To avoid falls and collisions causing injury to the user or others, parents/guardians should draw children's attention
to the safety precautions to be taken. Before using the product, it is important to explain to children how to use it
safely.
● The person using the product must always wear shoes.
● Assembly must always be carried out by an adult. Before each use, check that the item is not damaged or worn and
that all assembly and fastening parts are in good condition. Ensure that the bolts and nuts retain their auto-locking
properties. Check that the assembly is complete and in good condition. If you notice that some parts are missing or
damaged, do not use the product, but contact your retailer.
● Be careful when riding bicycles, you should know how to ride to avoid falls or collisions that could cause injury to the
user or a third person.
● The safest areas for the persons using the bicycle are those with little or no vehicular traffic, such as private areas,
playgrounds, schoolyards, and school playgrounds.
● This product is intended for a user with a minimum height of 74 cm and a maximum weight of 15 kg.
● Keep the packaging or dispose of it in accordance with local regulations.
● For the safety of children, do not leave parts of the packaging freely accessible (plastic bags, cardboard boxes, etc.).
Risk of suffocation!
I Bike components
1. Steering wheel
2. Pin
3. Front wheel, 2 pcs.
4. Frame with back wheel and saddle
5. Assembly wrench
II Assembling the bike
The first step is to install the pin (2) into the frame (4) (Fig. A.I). Then, put the steering wheel onto the pin (1) (Fig. A.II).
You need to follow the instructions precisely. The steering wheel should lock onto the latch provided at the top of the
pin (Fig. A.III). NOTE! If the steering wheel does not lock, slightly loosen up the nut (located at the bottom of the pin),
using the wrench (5) (Fig. B). Next, use your finger to press onto the thread and keep it in a position allowing the
steering wheel to lock on. Once the steering wheel is locked on, tighten the nut again. Install the front wheels (3) by
inserting them in the holes located at the bottom of the pin (2) (Fig. C).
How to remove front wheels? To remove front wheels, pull the lever located at the bottom of the pin, and then pull out
the wheel(s) (Fig. D).
How to adjust the saddle? To adjust the saddle level, use the lever located at the bottom of the bike frame (4) - pull it and
move the saddle to one of three available levels (Fig. E). The saddle may also be removed, using the lever, by pulling it
completely out of the frame.
Dear customer
Thank you for purchasing a Kinderkraft product.
12