Subaru F551SAN400 Mode D'emploi page 3

Install bracket (B) on the driver's side where the 2
7
mounting locations were. Hand-Tighten the top
bolt first, then use a 10mm socket to torque both
bolts to 8NM (70in-lbs).
T = 70.8±5 IN-LBF (8.0±0.56 N-M)
Install mesh (A) on the bracket studs (B, C).
9
Install flange nut (G) and large flat washer (F) to
11
the 2 studs on the right bracket. Hand tighten.
VERSION
01 04/16/19
DATE
SUBARU OF AMERICA
INSTALLATION INSTRUCTIONS
Install bracket (C) on the passenger side where
8
the 2 mounting locations were. Hand-Tighten the
top bolt first, then use a 10mm socket to torque
both bolts to 8NM (70in-lbs).
T = 70.8±5 IN-LBF (8.0±0.56 N-M)
Install flange nut (G) and large flat washer (F) to
10
the 2 studs on the left bracket. Hand tighten.
Tighten all four flange nuts (I) to T = 70.8±5 IN-
12
LBF (8.0±0.56 N-M) using a 10mm socket with
torque wrench. Torque in order shown.
T = 70.8±5 IN-LBF (8.0±0.56 N-M)
PAGE
3/8