Working Without The Automatic Leveller; Working With The Tripod - Parkside Performance PKLLP 360 B2 Instructions D'utilisation Et Consignes De Sécurité

˜ Working without the automatic leveller
NOTES:
The leveller light
without the automatic leveller . The laser lines depicted are not
levelled .
The product has 2 magnets
product to surfaces that attract magnetic objects, e .g . steel shelves .
m ATTENTION! The magnetic surface used should be flat and not
curved or uneven surface . Otherwise, the product will fall down and
will be damaged .
1 . Push the levelling slide switch
2 . Switch on the product .
˜ Working with the tripod
(Fig . B)
Screwing the laser onto the tripod mount
Screw the internal thread
screw .
22 ] [
Removing/inserting the tripod mount
1 . Open the lever
2 . Remove the tripod mount
3 . Place the tripod mount
4 . Lock the tripod mount
ATTENTION! Do not use excessive force . This may damage the
m
product .
will illuminate permanently in red when working
17 ] [
. The magnets allow you to attach the
[ 2 ]
[ 14 ]
of the product hand tight onto the tripod
[ 21 ]
.
6 ] [
in an upward direction .
19 ] [
on the tripod for insertion .
[ 19 ]
by closing the lever
[ 19 ]
to the right (closed lock) .
19 ] [
.
6 ] [
GB/IE 27