Automatic Selection - Esscom BUTLER E2100 TWIN Manuel D'utilisateur

Esscom Butler E2100 TWIN
 5HJLVWHUGHUHJLVWHU D KDQGVHW
 5HJLVWHU WR D %XWOHU ( EDVH
You can subscribe 5 handsets to one base unit. Each handset can register to 4 base stations
and the user can select which base he wants to use. By default, each handset is subscribed
on the base unit upon delivery (base unit 1).
<RX RQO\ QHHG WR VXEVFULEH WKH KDQGVHW LI
‡ 7KH KDQGVHW VXEVFULSWLRQ KDV EHHQ UHPRYHG IURP WKH EDVH XQLW HJ IRU
UHLQLWLDOLVDWLRQ 
‡ ,I \RX ZDQW WR VXEVFULEH D GLIIHUHQW KDQGVHW WR WKLV EDVH XQLW
The below procedure is only applicable to a Butler E2100 handset and base unit!
Remove the base power by unplugging the power cable at the back. Power up the base again
by plugging the power cable back in. The base will be in registration mode for 1 minute.
During this minute, you must do the following to subscribe the handset:
Press menu button
. Æ Select the number of the base unit you would like to subscribe the handset
2.
press
to (1-4) using the up
Enter the base pin code (0000) and press
Æ If the pin is wrong, the handset will mention it and will stop the registering procedure. Æ
When the handset is registered, it will show '+$1'6(7' followed by the handset number.
 5HPRYLQJ D KDQGVHW
You can remove a handset from a base to allow another handset to be registered:
Press menu button
. Æ Enter the pin code (0000) and press
2.
want to remove and press
is successfully.
<RX FDQ RQO\ UHPRYH H[LVWLQJ KDQGVHWV DQG RWKHUV WKDQ WKH RQH \RX DUH
XVLQJ
 6HOHFWLQJ D EDVH XQLW
If your handset is subscribed to several base unit stations (max. 4), you must select a base
unit because the handset can only communicate with one base unit at a time. There are two
possibilities:

8.3.1 Automatic selection

If you set handset to automatic selection, the handset will automatically choose the closest
base unit in standby:
Press menu button
. Æ Use the up
2.
press
. ÆUse the up
2.
14
. ÆUse the up
2.
or down button.Æ Press the menu/OK button
. ÆUse the down
2.
. Æ The unit will go back to the previous menu if the removal
2.
. ÆUse the up
2.
button to scroll to '6(/(&7 %$6(' and press
or down
or down button to select '$872' and press
or down button to scroll to '5(*,67(5' and
. Æ The unit will start searching for the base.
2.
button to scroll to ''(5(*,67(5' and press
. Æ Enter the handset number (1-5) you
2.
or down button to scroll to '+$1'6(7' and
to confirm Æ
2.
2. .
Esscom Butler E2100 TWIN