Ozone OXYGEN 1 Manuel D'utilisation page 5

FOLDING
To ensure the long life of materials, it is important to reverse the
harness carefully so that no buckles or other sharp objects pro-
trude into the rucksack fabric. Follow the method shown below;
Connect all buckles (leg straps and chest strap).
Fold over Leg supports toward the middle keeping
all straps and buckles underneath. Tighten shoulder
straps.
Reverse back section.
Insert glider and helmet.
Double check there is nothing sharp protruding
that could damage the material of the rucksack.
TOWING
The Oxygen1 is suitable for towing. The tow release should be
connected to the main karabiners. If in doubt ask a qualified tow-
ing instructor or see operating instructions supplied with your tow
release.
CARE AND MAINTANENCE
The Oxygen will last you many flights and many years if looked
after correctly. To keep your harness clean and airworthy, please
note the following:
• Avoid excessive exposure to UV, heat and humidity.
• Pack the harness dry and store in a cool dry place.
• Never drag your harness.
• Keep you harness clean of dirt, oils and any corrosive substance.
Use water and a cloth to clean.
Inspection
For safety, routine inspection of all of your equipment is vitally
important. Ozone recommends a service interval of 6 months in
addition to the usual pre flight checks.
For inspection, visually check the stitching, webbing and all struc-
turally important areas. Pay particular attention to the webbing
around the hang point area under the karabiner, as this is where
abrasion is most likely.
If you find any damage or if you are in any doubt make sure the
harness checked by a professional.
MATERIALS
Bag - Ripstop Nylon/Oxford 210Denier, PU coating 2 TIMES 0.8MM
Harness - 600 Denier Polyester Oxford cloth.
Buckles – SupAir frame buckles, Austria Alpin quick release.
Webbing – From Gurth and Wolf, 20mm Polyamide, breaking
strength 1700 kg.
6
Manual d'utilisation FR