Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Steps - Tailgate
4
Rotate support bracket counter-clockwise to
give access to right side hinge hardware.
Remove factory hardware on the right side of
both the top and bottom hinges.
5
Rotate support bracket clockwise, lining up
the bottom right hole with the corresponding
mounting point in the tailgate and hinge.
Using provided hardware (8mm on JK and
10mm on JL), insert bolts with flat washers
through Jack Mount, through Support Bracket,
through Spacer and into the tailgate.
Snug hardware but do not tighten fully.
6
Bolt top hole of Support Bracket to Jack Mount
using provided 8mm x 15mm bolt, flat washer
and flange nut.
7
Tighten all hardware.
For Off-Road Jack Install, Go To Step 10.
NOTE: Actual application may vary slightly from illustrations.
Page 3 of 6
Publicité
Table des Matières
