Axis Communications T8516 PoE+ Guide D'installation page 11

AXIS T8516 PoE+ Network Switch
Important
If a mini-GBIC is installed in slot 17-18, the associated RJ-45 port 17-18 is disabled and
cannot be used. Make sure the network cable is not connected to RJ-45 port 17-18 when
you install or remove a mini-GBIC.
1. Insert the module into the SFP slot.
2. Press firmly to ensure that the module seats into the connector.
Power notice
The product is a power-required device, meaning it will not work until it is powered. Consider using
an UPS (Uninterupted Power Supply) in order to avoid network data loss or network downtime.
Installing a surge suppression device may also help to protect the product from being damaged by
unregulated surge or current to the product or the power cord.
How to use the Mode/Reset button
By pressing the Mode/Reset button for certain period of time, users can perform the following tasks.
• Change between port status mode Link/Act/Speed and PoE.
• Reset the product to the previous configuration settings saved.
• Restore the product to the original factory default settings.
Mode/Reset button
Task to be performed
Change port status
mode between
Link/Act/Speed and
PoE
Reset the product
Restore to the original
factory default
settings
Time period of
pressing button
0-2 seconds
2-7 seconds
7-12 seconds
LED
Green (lit)
Green (blink)
Green (blink)
10
Port status LED
behavior
LED status changes
according to the
selected mode.
The lights are OFF for
all LEDs
The lights are ON for
all LEDs