Installation - Sonnenkonig VENTUS DIESEL 50 Mode D'emploi

04 - INSTALLATION

A
Handle
B
Plain washer ø6 mm
C Clamping screw
D Wheel
E wheel shaft
F
Plain washer ø12 mm
G
Nut M12
H
wheel cover
I
Cotter
J
caster fixing plate
1. Insert the wheel shaft (E) into the corresponding hole of the caster fixing plate (J), insert the cotter
(I) to the corresponding holes of the wheel shaft; put plain washer (F) to the two sides of shaft,
slide the wheel (D) over the wheel shaft (E), screw the nut (G) to fix the wheel on the shaft Install
the wheel cover (H).
2. Use the clamping screw (C) and Plain washer ø6 (B) to install the Handle (A) into thecorresponding
hole of the caster fixing plate (J).
EN
42
1 pcs.
4 pcs.
4 pcs.
2 pcs.
1 pcs.
2 pcs.
2 pcs.
2 pcs.
2 pcs.
2 pcs.