Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Powering the Base
1. Plug the power adapter into the DC jack on the base.
2. Connect the power adapter to a wall power outlet.
Docking the Headset/Charging
1. Press the Multi Function button on the headset
will light up for 2 seconds indicating it is powering on. Press
the Multi Function button again, or dock the headset on the
Base Unit. Lift the headset: when the headset and base are
connected, the Headset Paired LED will light up.
2. When docked correctly, the headset battery
charging, if needed (the LED will flash while charging).
Charge for 20 minutes or until the battery indicator on the
base is steady green.
3. To Clear the paired Base Unit and headset: Press the button
marked R + at the back of the base. The battery charging
status light will flash 3 times to indicate successful un-pairing.
4. To Re-pair with the headset: press and hold the PAGE button
for 5 seconds. The headset paired light
indicate the Base Unit is searching for the headset. Press
and hold the headset mute button until the headset status
LED flashes indicating the headset is in paired status. The
connection will be successful when the LEDs shut off at the
same time.
Configuring the PC Audio
Due to the large range of desk phone brands/models available,
a clear dial tone must be set before your first use of the ZūM
Maestro USB™ headset. Setting a clear dial tone will enable
the ZūM Maestro USB™ headset to function correctly with your
computer for use with Skype, Skype for Business or other VoIP
Spracht®
. The LED
➎
will begin
will flash to
2
Publicité
Table des Matières
