auna TT-Play PLUS Mode D'emploi page 22

EN
20
Remarks
• Some types of records may have an auto-stop area outside the preset
limit, so the turntable may stop before the last track finishes. In this
case, set the Auto Stop On/Off switch (6) to the "OFF" position. This
allows the record to play to the end, but please note that it will not stop
automatically. You must manually raise the tone arm and place it back in
the rest and then turn off the power to stop the turntable from spinning.
• Users should not change to a ceramic cartridge system, otherwise unit
can´t be connected anymore to an Aux-in of music-centre
Platter speed fine adjustment
• During playback of record, turn the Pitch Adjustment (12) to fine adjust
the platter rotation speed.
• Turning clockwise (+) will increase the turning speed and anti-clockwise
will slow down the speed.
• Turn the Pitch Adjustment until the output sound performance is up to
your satisfaction
BT connecting and Playback
1. Press the Power Button (4.), the BT Indicator (2.) will light up.
2. The BT LED indicator (2.) will be flashing, it means the BT in non
connection / searching mode.
3. Switch on the BT feature of your BT device (such as mobile phone) and
select "TT-Play PLUS " BT equipment to connecting.
4. Once the connecting was finish and connect successfully, the BT LED
indicator (2.) will light up.
5. Start to playback your BT device and enjoy the music by the main unit.
6. Adjust the Volume + / - Button (5.) to the desire level.
Remarks
• Press the Power Button (4.) to disconnect the BT connection and the
unit will switch to Phono function.
• Press the play / pause / skip button of your BT device for operation.
Due to ErP stage two requirement and protect the environment, the unit will
switch to standby mode automatically when no any music playing over 15
minutes.