Installing A Pre-Wound Reel - MTD Yard-Man YM25 Manuel De L'opérateur

SECTION 7: MAINTENANCE AND REPAIR INSTRUCTIONS
3. Pull old line out of the line loading and line locking
holes. See Figure 16 and 17.
4. Insert a piece of trimming line straight into one of the
two eyelets in the outer spool. Push it up through the
line loading hole in the inner reel. See Figure 16. Do
not bend the line when inserting it into the eyelet.
Trimming Line
Eyelet
Line Loading Hole
Figure 16
5. Insert the line into the locking hole. Do not push the
line more than a 1/2 inch (12.7 mm) into the line
locking hole. The line will form a small loop when it is
inserted correctly. See Figure 17.
Line Locking Hole
Figure 17
6. Pull the line from the outer spool until the line is tight
against the inner reel. See Figure 18.
Figure 18
7. Repeat procedures 4-6 with the second piece of line.
8. Hold the outer spool. Wind the inner reel
counterclockwise until approximately four (4) inches
(102 mm) of line remain. See Figure 19.
NOTE: Do not wind the inner reel before installing the
second piece of line.
9. If winding the line becomes difficult or if the line
jams, pull the ends of the line from the spool. See
Figure 20. Continue winding the inner reel
counterclockwise.

Installing a Pre-wound Reel

1. Turn the bump knob counterclockwise and remove
the bump knob, spring and foam seal. See Figure 21.
Bump Knob
Foam Seal
Spring
Inner Reel
13
Figure 19
Figure 20
Figure 21