Publicité
SAFETY INFORMATION
The multimeter has been designed according to IEC 61010 concern-
ing electronic measuring instruments with a measurement category
(CAT III 600V) and pollution degree 2.
WARNING
To avoid possible electric shock or personal injury, follow these
guidelines:
Do not use the meter if it is damaged. Before you use the
●
meter, inspect the case. Pay particular attention to the insulation
surrounding the connectors.
Inspect the test leads for damaged insulation or exposed metal.
●
Check the test leads for continuity. Replace damaged test leads
before you use the meter.
Do not use the meter if it operates abnormally. Protection may
●
be impaired. When in doubt, have the meter serviced.
Do not operate the meter where explosive gas, vapour, or dust is
●
present.
Do not apply more than the rated voltage, as marked on the
●
meter, between the probes or between any probe and earth
ground.
Before use, verify the meter's operation by measuring a known
●
voltage.
When servicing the meter, use only specified replacement parts.
●
Use caution when working with voltage above 30 V AC RMS, 42
●
V peak, or 60 V DC. Such voltages pose a shock hazard.
All manuals and user guides at all-guides.com
2
Publicité
