Cameo MOVOBEAM ZOOM 100 CLMBZ100 Manuel D'utilisation page 6

MAIN DISPLAY SLAVE MODE
The preset DMX mode is shown in the top line of the display with "SLAVE" clearly visible at the centre. As soon as the control signal is
interrupted, the display begins to flash. When there is a signal again, the display will stop flashing.
DMX 36 Ch
Operating Mode
SLAVE
MAIN DISPLAY STANDALONE MODE
The preset DMX mode is shown in the top line of the display with the currently activated auto mode (AUTO1 - AUTO8) or the static mode
STATIC clearly visible at the centre.
DMX 36 Ch DMX 36 Ch
Operating Mode Operating Mode
AUTO1 STATIC
SET DMX START ADDRESS (ADDRESS)
Press MODE to access the system settings selection menu. Now use UP and DOWN to select the menu item "ADDRESS" (shaded in colour)
and confirm with ENTER. The sub-menu item "Set DMX Address" is then displayed. Press ENTER again to set the DMX start address as re-
quired using UP and DOWN. If the start address is changed, the colour of the address changes to red. Confirm with ENTER and press MODE
twice to return to the main display. The main display is activated automatically after approximately 30 seconds of no input.
DMX 36 Ch DMX 36 Ch
ADDRESS 001 Set DMX Address
MODE DMX 36 Ch
Setting
System Info
SET DMX MODE (DMX Mode)
Press MODE to access the system settings selection menu. Now use UP and DOWN to select the menu item "MODE" (shaded in colour) and
confirm with ENTER. Use UP and DOWN once again to select the sub-menu item "DMX Mode" and confirm with ENTER. Now use UP and
DOWN to select the required DMX mode (DMX 5 Ch, DMX 16 Ch, DMX 36 Ch) and confirm with ENTER. Press MODE twice to return to the
main display . The main display is activated automatically after approximately 30 seconds of no input. Tables with the channel assignment
of the different DMX modes can be found in these instructions under DMX CONTROL.
DMX 36 Ch DMX 36 Ch
ADDRESS 001 DMX MODE
MODE xxx Slave
Setting Auto
System Info Static
SET SLAVE MODE (Slave)
Press MODE to access the system settings selection menu. Now use UP and DOWN to select the menu item "MODE" (shaded in colour) and
confirm with ENTER. Use UP and DOWN once again to select the sub-menu item "Slave", confirm with ENTER and press MODE twice to
return to the main display. The main display is activated automatically after approximately 30 seconds of no input. Connect the slave and
master units (same model) using a DMX cable, and enable one of the standalone modes on the master unit (Auto, Static). The slave unit will
now follow the master unit.
DMX 36 Ch DMX 36 Ch
ADDRESS 001 DMX MODE
MODE xxx Slave
Setting Auto
System Info Static
6
DMX 36 Ch
001
Set DMX Address
001
DMX 36 Ch
Yes DMX 5 Ch
DMX 16 Ch
DMX 36 Ch Yes
Yes