Important Operating Instructions; Amplifier In-Use Notices - Paradigm X Serie Manuel Du Propriétaire

IMPORTANT SAFETY INSTRUCTIONS
19. Replacement Parts – When replacement parts are required, be sure
the technician has used replacement parts specified by the manufacturer
or have the same characteristics as the original part. Unauthorized
substitutions may result in fire, electric shock, or other hazards.
20. Safety Check – Upon completion of any service or repairs to this
product, ask the service technician to perform safety checks to determine
that the product is in proper operating condition.

IMPORTANT OPERATING INSTRUCTIONS

USING YOUR AMPLIFIER WITH A 'REFERENCE' RVC SUBWOOFER:
TO PREVENT DAMAGE TO AMPLIFIER OR SUBWOOFER, THE IMPEDANCE MATCHING
SWITCH ON YOUR 'REFERENCE' RVC SUBWOOFER'S BAFFLE MUST BE CORRECTLY
POSITIONED (See Fig. 2).
(all models)
1. DO NOT connect to power if there are any signs of damage to any part
of the exterior.
2. Depending on the level of the input signal, the voltage at the outputs
can be high enough to cause electric shock. Turn all components OFF
before connecting the amplifier.
3. Allow adequate ventilation to ensure reliable operation and prevent
overheating. The amount of space required above the unit for radiation
depends on ambient air temperature and circulation. Installation inside
a cabinet with a front that can be closed is NOT recommended unless a
fan is installed to adequately draw air away from the top of the unit.

AMPLIFIER IN-USE NOTICES

1. Disconnect the power cord before connecting or disconnecting any
components.
2. DO NOT remove top cover: there are no user-serviceable parts inside.
3. DO NOT modify the product.
3
(continued)
21. Heat – The product should be situated away from heat sources such
as radiators, heat registers, stoves, or other products (including amplifiers)
that produce heat.
4. Failing to comply with any safety instruction, precaution or warning
in this Operating Manual is in direct violation of the standards of
design, manufacture and intended use of this product. Paradigm and
any related party assume no liability for the user's failure to comply
with these requirements.
(all models)
4. The Auto-On/Trigger switch on the rear panel of selected models will
NOT turn the amplifier off or disconnect it from the AC line source. It can
only initiate the amplifier's standby mode. It is necessary therefore to
ensure the power cord remains readily accessible at all times.