Subwoofer Connection - Paradigm X Serie Manuel Du Propriétaire

SUBWOOFER CONNECTION

IMPORTANT! Before proceeding with this section, be
sure to read all Safety Precautions and Safety and
Operating Instructions included at the beginning of
this manual.
Turn all components OFF before connecting
the amplifier.
This Owners Manual applies to more than one Paradigm
Connection options vary by model. Examine your amplifier's rear panel to
Input Facilities
Line-Level RCA Input (Figs. 3a – 3b)
1. Mono Input (Left, Right, or Sub-Out) connects from the RCA (S/E)
Sub/LFE-Output of your Preamplifier/Processor, A/V Receiver or other
suitable low level source (Fig. 3a).
2. Stereo Input (Left & Right) connects from the Stereo Preamplifier, Stereo
Receiver or other suitable line-level stereo source (Fig. 3b).
NOTE: DO NOT use RCA-compatible connectors that have a hollow center
pin with a hole at the tip—inserting these into the amplifier's RCA jacks can
cause internal damage.
The USB Port
Your amplifier has a USB port, it will allow for:
• Configuring your system for optimal sound with or without a Paradigm
Backbox (sold separately) , using the setup CD included with amplifier;
SUB 1 Output and SUB 2 Output (Figs. 5a – 5c)
Connecting Two PCS Subwoofers (Fig. 5a): Connect Red (+) speaker cable to
positive SUB 1 (+) Output and Black (-) speaker cable to SUB 1 (-) Output.
For second subwoofer, connect Red (+) speaker cable to positive SUB 2 (+)
Output and Black (-) speaker cable to SUB 2 (-) Output.
Connecting Four PCS Subwoofers (Fig. 5a): Connect Red (+) speaker cable to
positive SUB 1 (+) Output and Black (-) speaker cable to SUB 1 (-) Output.
For second subwoofer, connect Red (+) speaker cable to positive SUB 2 (+)
Output and Black (-) speaker cable to SUB 2 (-) Output. For third and fourth
subwoofers, repeat instructions in same order.
Connecting 3 PCS Subwoofers not shown.
NOTE: Speakers set to "Large" with your processor or A/V receiver will still
be reproducing bass frequencies—be careful not to overdrive them!
We recommend the use of high-quality cables and connectors. (See your
Dealer for more information.)
® X-Series amplifier. determine the input(s) that apply to your model, then choose the one that
best suits your needs.
Line-Level Input — Balanced XLR (Fig. 4)
Connects from the Balanced XLR Sub/LFE Output of your Preamplifier/
Processor, A/V Receiver or other suitable line-level source. This input provides
the lowest noise and distortion possible. It is particularly important for long
cable runs where noise and distortion could degrade performance.
• Future upgrades to software installed in your subwoofer amplifier;
® • Use with the Paradigm Perfect Bass Kit room correction system (sold
separately)
Connecting One RVC Subwoofer (Fig. 5b): Connect Red (+) speaker cable
to positive SUB 1 (+) Output and Black (-) speaker cable to SUB 1 (-) Output.
Connecting Two RVC Subwoofers (Fig. 5c): Connect Red (+) speaker cable to
positive SUB 1 (+) Output and Black (-) speaker cable to SUB 1 (-) Output.
For second subwoofer, connect Red (+) speaker cable to positive SUB 2 (+)
Output and Black (-) speaker cable to SUB 2 (-) Output.
NOTE: If you are connecting more than two RVC subwoofers you will require
an additional X-850 amplifier, connected to its own AC circuit.
10