Black & Decker ACCU-TRAK SAW SCS600 Manuel D'instructions page 5

FUNCTIONAL
DESCRIPTION
1.) Trigger switch
2.) Lock-on button
3.) Blade change lever
4.) Blade clamp
mechanism
5.) Smart Select dial
6.) Shoe
7.) Straight cut guide
8.) Blade storage door
9.) Front handle
SAVE THESE INSTRUCTIONS
SWITCHING ON AND OFF (FIGURE B)
- To switch the tool on, squeeze the trigger
switch (1).
- For continuous operation, squeeze the
trigger switch then depress the lock-on button
(2). Once lock-on button is depressed, release
the trigger switch.
- To switch the tool off, release the trigger
switch. To switch the tool off, when in
continuous operation, squeeze the trigger and
the lock will disengage.
VARIABLE SPEED CONTROL
Variable speed is controlled through trigger switch (1). The tool speed depends on how far
you depress the trigger. For best results, start your cut by gently squeezing the trigger
(slow speed) and gradually speed up (squeeze trigger more) as you move through your cut.
BLADE INSTALLATION AND REMOVAL
WARNING: Turn off and unplug the tool
before making any adjustments or
removing/installing attachments or accessories.
NOTE: This saw uses only T-shank jig saw
blades.
TO INSTALL A BLADE (FIGURE C):
1.Lift the blade change lever (3).
2. Insert the T-shank blade into the clamp
mechanism (4) while guiding the back of the
blade into the groove of the guide rollers.
3. The T-shank should be completely inside
the clamp mechanism as shown in figure C.
4. Release the blade change lever.
TO REMOVE A BLADE
1. Lift the blade change lever (3).
2. With a slight shake of the tool, the blade will
drop out.
All manuals and user guides at all-guides.com
A
9
5
3
4
7
OPERATION
B
C
5
2
1
8
6
1 2
3
4