Specifications - MTD Yard-Man 769-00857 Manuel De L'opérateur

UNIT WILL NOT START
C A U S E
Unit is unplugged
Starter button or bail were improperly used
Overload protection switch has popped out
MOTOR IS ON, BUT ROTOR WILL NOT TURN
C A U S E
Belt is damaged
UNIT LEAVES A THIN LAYER OF SNOW ON PLOWED SURFACES
C A U S E
Scraper is worn
If further assistance is required, contact your authorized service dealer
MOTOR*
Motor type......................................................................................................................................... A.C.,120 Volts Electric
Operating RPM......................................................................................................................................... up to 14,000 rpm
Ignition Switch................................................................................................................................. Bail Lock Safety Button
Amperage............................................................................................................................................................... 8.5 amps
Overload Protection .......................................................................................................................... 120V, 15 amp Breaker
DRIVE SHAFT ASSEMBLY AND SNOW THROWER UNIT*
Handles ............................................................................................................................................................... Steel Tube
Approximate Unit Weight ............................................................................................................................... 20 lbs. (9 kg.)
Snow Depth (maximum) .................................................................................................................. 6 inches (0.152 meters)
Cleared Path Width..................................................................................................................... 12.5 inches (0.318 meters)
*All specifications are based on the latest product information available at the time of printing. We reserve the right to
make changes at any time without notice.
TROUBLESHOOTING
Check cord to make sure it is plugged into an electrical outlet
Press in starter button, hold it, and hold bail
Push it in and follow the Starting Instructions
Replace the belt, according to Inspecting/Replacing the
Driver Belt
Replace the scraper

SPECIFICATIONS

A C T I O N
A C T I O N
A C T I O N
13