Powering On / Off - Aukey DRA2 Mode D'emploi

(a) Ensure your car is safely parked in a flat place
(b) Remove trim to get access to the wiring system connections
inside the trunk
(c) Identify the reversing light wiring. Use a voltmeter to find the wire
that's only live (with about +12V) when your car is in reverse
(d) Hardwire to this wire using a soldering or 'military splice' method
and seal with electrical tape
7.
Switch on the car ignition to power the 12V/24V outlet. The dash
camera system will power on and start recording automatically.
Check that both cameras are operating correctly and are
positioned well for the best view. The mirror dash camera has a
pivoting lens barrel and the rear camera tilts on its bracket
Caution
AUKEY is not responsible for any damage caused to or by the air bag
due to incorrect placement of the device or its cables

Powering On / Off

Press and hold the power button for 3 seconds to turn the dash camera
on/off. After the dash camera is turned on, short-press the power button
to turn the screen on/off (recording continues). 'Auto Screen Off' and
'Auto Power-Off' in 'General Settings' can be used to turn the screen or
the dash camera off automatically after 1 or 3 minutes.
Using the Touchscreen Buttons
09:00
2019/01/01
- 07 -