Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
SET UP

CHARGING YOUR SPEAKER

The "Chill Out" speaker is powered by a rechargeable
battery. The speaker comes pre-charged; however, for
optimal play time, make sure to charge before first
use.
A – Open the bottom door on the speaker and take
out the spool. Unwrap the integrated charging cable,
open the door on the side of the speaker, thread the
micro USB end through the door, and plug it into the
charging port on the speaker.
B – Connect the larger USB plug to your computer
or a powered USB AC adapter. An AC adapter is not
included in the box, but you can use the one for your
cell phone or pick one up next time you're at the
store.
C – When the LED flashes red, it indicates that the
battery is low and it's time to plug in and recharge.
Charge for about 2 hours to get up to 8 hours of play
time; while charging, the light will stay solid red. Once
fully charged, the LED will turn off.
USE
A – TURN ON YOUR SPEAKER
Long press the "play/pause" button for 3 seconds to
turn on your speaker.
B – CONNECTING TO A DEVICE
Once turned on, the speaker will immediately search
for a device to pair to. The LED will start blinking
blue then switch to blinking red and blue alternately.
Enable Bluetooth on your device. From the Bluetooth
menu, select "Chill Out." When the device and Chill Out
are connected, you will hear a tone and the LED light
will turn solid blue momentarily then move to a slow
blinking blue.
You may also connect your device to Chill Out using
an aux cord, which is included. When plugged in, the
light will turn solid red.
Note: Holding down the "X" and "play/pause" buttons
at the same time, for 2 seconds, will disconnect the
speaker from your device.
EN
3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hx-p202

Table des Matières