Replacing The Lamp - AEG S53600CSS0 Notice D'utilisation

All manuals and user guides at all-guides.com
Problem
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.
The temperature in
the refrigeration is
too high.
The temperature in
the freezer is too
high.
The appliance does
not operate.
The lamp does not
work.
If your appliance is still not working
properly after making the above checks,
contact the After Sales Centre.

7.1 Replacing the lamp

The appliance is equipped with a long-
life LED interior light.
1. Disconnect the appliance.
2. Push the movable part to unhook
the lamp cover (1).
3. Remove the lamp cover (2).
Possible cause
The Temperature regula-
tor may be set incorrectly.
The Temperature regula-
tor may be set incorrectly.
The door is not closed
correctly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
The appliance is switched
off.
The mains plug is not
connected to the mains
socket correctly.
The appliance has no
power. There is no volt-
age in the mains socket.
The lamp is in stand-by.
The lamp is defective.
4.
5.
6.
7.
Solution
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the
door".
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Store less products at the
same time.
Make sure that there is
cold air circulation in the
appliance.
Store products so that
there is cold air circulation.
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electri-
cal appliance to the mains
socket. Contact a qualified
electrician.
Close and open the door.
Refer to "Replacing the
lamp".
If needed replace the lamp with a
light of similar characteristic and
power. It is suggested to use Osram
PARATHOM SPECIAL T26 0.8 Watts.
Install the lamp cover.
Connect the appliance.
Open the door. Make sure that the
lamp comes on.
ENGLISH
27