Rapid EG360 Notice Technique page 7

with the device being hot.
- Place the tool on its stand.
Leave it plugged in and heat-
ed. Purge the tool by letting
the hot glue flow out under
gravity, onto a disposable
support (container, paper,
cardboard,..).
- Insert a new glue stick, push-
ing lightly on the trigger.
- Pull the trigger a few times,
to make sure that the old glue
has been completely cleared
and the tool has been com-
pletely purged.
- Replace the nozzle with a new
one.
• In any case, you should never:
- Force the trigger before the tool
has heated up to its working
temperature
- Push hard on the glue stick,
never attempt to remove it from
the back.
• Repair work on the glue gun
should be carried out by qualified
staff only.
• If the power supply cable is dam-
aged it must be replaced by the
manufacturer, the manufacturer's
after sales service or a similarly
qualified person in order to avoid
any danger.
Electric wiring diagram
300W
Heater
ON/OFF Switch
Thermostat
Fuse
AC 220 - 240V
ENVIRONMENT
Separate Collection. Do not
dispose power tools into
household waste! Accord-
ing to the European Directive
2012/19/EC on waste of electrical
and electronic equipment.
When the tool needs to be re-
placed, or if it is of no further use
it should be brought to a separate
collection centre for recycling.
Warranty and repairs under war-
ranty
Warranty period: This product is
guaranteed for 2 years from the
date of purchase (original sales
receipt acting as proof).
Warranty conditions: All points
mentioned in this document must
have been fully adhered to.
Warranty repairs: The Es-
selte-Rapid After-Sales Service is
the only approved service to carry
out warranty repairs on this tool.
In the event of a claim under the
warranty:
1 Return the product in its original
packaging to the shop or outlet
that supplied you with this prod-
uct,
2 Accompany the returned product
with the original dated receipt.
Any breach of one of these
points would prevent
consideration by RAPID under
the manufacturer's warranty.
7