KitchenAid 8573755 A Instructions D'installation page 14

12. Feed the medallion wires through the wire opening in the
metal plate.
wire opening
13. Lay the metal plate on the back of the custom door panel.
14. Align the centerline marked on the custom door panel with the
diamond shape and notch in the metal plate to center the
metal plate horizontally. Align the horizontal line with the top
of the metal plate.
centerline
15. Using the screws provided, fasten the metal plate to the door
panel through the 3 inner holes (per side).
3 inner holes
16. Connect the medallion connector to the dishwasher
connector.
14
metal plate
door panel
horizontal line
top of plate
lower door
panel
end of medallion
connector
17. Slide the metal plate tabs into the notches and slots on the
dishwasher and gently pull up to lock in place.
18. Line up the bracket holes with the pin holes and replace each
pin so that the pin line is vertical.
pin
19. Repeat steps 2–15 for other custom door panel.
Option 2: Install custom toe panel (on some models)
Custom toe panel dimensions
⁵⁄₃₂
2 "
(55 mm)
5" (12.7 cm)
max.
(varies)
The black prefinished toe panel can also have a custom front
panel with a thickness from ³⁄₈" to ³⁄₄" (9–19 mm) attached to it.
Determine the height of the toe panel custom panel: The
minimum height is 2³⁄₄" (70.5 mm). Measure from the top of the
adjacent cabinet door front to the floor. Subtract 28¹⁵⁄₃₂"
(72.3 cm) for needed toe panel height.
NOTES: Depending on countertop height, you may not have to
trim the toe panel.
Rugs placed in front of dishwasher could interfere with
toe panel. Clearance between floor and toe panel may
need to include the rug thickness.
1. Prepare the custom toe panel to specifications shown above.
2. Lay the custom toe panel face down.
¹⁄₂
23 " (59.7 cm)
17" (43.2 cm)
¹⁄₂
" (12.7 mm) radius