Install Drain Hose - KitchenAid 8573755 A Instructions D'installation

Install the Drain Hose
NOTE: Drain hoses will need to be separated to satisfy kosher
requirements. Confirm acceptability with your local Rabbi in
respect of kosher installations.
A drain hose extension kit, part no. 8194400, will extend the drain
hose to a length of up to 141 ³⁄₄" (360.05 cm). Do not extend
beyond this length. The maximum drain height is 37 ¹⁄₂"
(95.25 cm).
Option 1: Sink drain waste tee
connection
1. Route the drain hoses as shown and
press the hoses into the drain hose
support.
2. Decide if the drain hoses need to be
trimmed. If they do, trim them.
3. Slip a wire clip over each drain hose.
Push the hoses into the drain hose connector firmly, 5 clicks.
4. Position the wire clips between the two positioning ribs on the
drain hose connector.
5. Attach the drain hose connector to the waste tee using the
supplied hose clamp.
6. Attach the drain hose support bracket to the cabinet with a #8
Phillips head screw at the height shown below.
IMPORTANT: The drain hose connector must not support the
weight of excess hoses. A drain loop must be provided as
shown in the Installation Instructions. Keep hoses as fully
extended as possible to prevent sagging. Any excess length
of hose should be kept on the dishwasher side of the drain
loop.
drain hose
support
10
wire clip
wire clip
drain hose
connector
6" (15.2 cm)
minimum
waste
waste
tee
water supply
Keep drain
hose straight
as shown.
Option 2: Garbage disposal connection
1. Route the drain hoses as shown and press the hoses into the
drain hose support.
2. Decide if the drain hoses need to be trimmed. If they do, trim
them.
3. Slip a wire clip over each drain hose.
Push the hoses into the drain hose
connector firmly,
5 clicks.
4. Position the wire clips between the
two positioning ribs on the drain
hose connector.
5. Attach the drain hose connector to the garbage disposal
using the supplied hose clamp.
6. Attach the drain hose support bracket to the cabinet with a
#8 Phillips head screw at the height shown below.
IMPORTANT: The drain hose connector must not support the
weight of excess hoses. A drain loop must be provided as
shown in the Installation Instructions. Keep hoses as fully
extended as possible to prevent sagging. Any excess length
of hose should be kept on the dishwasher side of the drain
loop.
drain hose
support
valve
wire clip
wire clip
drain hose
connector
6" (15.2 cm)
minimum
garbage
disposal
waste
water supply
8" (20.3 cm) min. bend
radius from valve
Keep drain
hose straight
as shown.