Use For Intended Purpose - Cartrend 10699 Notice D'instructions Originale

ai158262451737_108316_Cartrend_10699_Akku-Poliermaschine_BAL_110220.pdf
Suitable measures include, among other things, regular maintenance and care of the power tool and tool
attachments, keeping hands warm, taking regular breaks, and good planning of the working procedures.
Note concerning noise pollution
A certain amount of noise caused by this tool cannot be avoided. Reschedule noise-intensive work to
approved times that are intended for this purpose. If necessary, adhere to quiet periods and limit the
duration of the work to that which is necessary. Appropriate hearing protection must be worn for your
personal protection and for the protection of people in the vicinity.

USE FOR INTENDED PURPOSE

The polisher is used to polish and seal the surface of the paint of cars.
The machine may only be used for its intended purpose. Any other use is considered to be improper.
The user / operator is liable for damage or injuries caused by improper use and / or disregard
of the safety and usage instructions, not the manufacturer.
Please note that our devices are not intended for commercial, trade or industrial use. We do not accept
any liability if the device is used in commercial, trade or industrial companies or equivalent activities.
Failure to use the power tool for its intended purpose can result in hazards and injuries. Do not use
accessories that are not specifically intended for this power tool.
COMMISSIONING
Inserting and removing the battery:
· The polishing machine must always be switched o before inserting or removing the battery.
· To remove the battery, press in the tabs on the side of the battery and pull the battery out.
· When inserting the battery, please ensure that the ridge on the battery slides into the ridge
of the polishing machine.
· Now push in the battery firmly until it engages.
· If the ridge on the battery does not correspond with the ridge on the polishing machine,
the battery cannot be inserted.
Charging the battery:
To use the charger, please plug the mains adapter into a socket and then insert the battery into
the charger. Ensure that the ridge on the battery slides into the ridge on the charger. If the battery has
been inserted correctly, the red LED on the charging device must now illuminate and therefore indicate
that charging is in progress. If the LED does not illuminate, even after plugging in the battery repeatedly,
the battery is defective and must be replaced with a new one. When charging is complete, unplug
the mains adapter from the socket.
Charging the battery
1
Operational readiness:
The charger illuminates in green
1-The green light illuminates when the charger is connected to the power supply and the battery pack
has not yet been inserted into the charger.
2-The red light illuminates when the battery pack is inserted into the charger and is being charged.
3-The green light illuminates again when the battery pack is fully charged.
Battery status indicator:
The 3 battery status indicators show the capacity of the battery pack when the device is switched on.
If all 3 battery status indicators are illuminated, the battery pack is full.
Charge the battery pack when only one battery status indicator is illuminated.
14
2 3
Charging:
Fully charged:
Charger red light
The charger illuminates in green
14 25.02.20 10:55