Lighting The Side Burner - Signature 1500111 Instructions De Montage Et D'entretien

MATCH LIGHTING THE MAIN BURNER:
1. Open lid before lighting burner.
2. Make sure all control knobs are in the "OFF" position.
3. Place a paper match in the end of the matchlighter. Strike the match and place
through the cooking grate approximately 1.57 cm/1/2 in from the burner to be lit.
4. Turn the burner control knob to the "HIGH" position. The burner should light within
5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for
gas to dissipate and repeat lighting procedure.
6. Once lit, light adjacent burners by following steps 3-6.
7. If the burner does not light within the first few attempts of match lighting, there is
a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT
attempt to operate the grill until the problem is found and corrected.
Note: If burner does not light or flame is too low, See "Trouble Shooting" section
of the owners manual.

LIGHTING THE SIDE BURNER:

1. Open lid before lighting side burner.
2. Make sure all control knobs are in the "OFF" position.
3. Push and turn side burner control knob to the "HIGH" position.
4. Press the electronic igniter on the main control panel and hold for 3-5 seconds to
light burner.
5. If ignition does NOT occur in 5 seconds, turn control knob to "OFF", wait 5 minutes
to allow gas to dissipate and repeat lighting procedure.
Note: If burner does not light or flame is too low, See "Trouble Shooting" section
of the owners manual.
MATCH LIGHTING THE SIDE BURNER:
1. Open the lid to the side burner before lighting.
2. Turn the burner control knob to "OFF".
3. Place a paper match in the end of the matchlighter.
4. Strike the match and hold it approximately 1.57 cm/0.61 in from the burner.
5. Turn the side burner control knob to the "HIGH" position. The burner should light
within 5 seconds.
6. If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for
gas to dissipate and repeat lighting procedure.
7. If the burner does not light within the first few attempts of match lighting, there is
a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT
attempt to operate the grill until the problem is found and corrected.
Note: If burner does not light or flame is too low, See "Trouble Shooting" section
of the owners manual.
Note: Observe flame height when lit: Flame should be a Blue/Yellow color between
2.54 cm - 5.08 cm/1 in - 2 in when burner is on "HIGH"
See section in manual on burner adjustment to adjust flame.
9
All manuals and user guides at all-guides.com
Matchlighter