Changing The Gas Cylinder - Russell Hobbs RHG03 Instructions

TURNING THE GAS HEATER "OFF"

Turn the heat control knob to ( 0 )

Turn OFF the gas clockwise

The flame at the bottom of the centre panel should automatically extinguish itself. Should
it not do so, check that the gas cylinder is OFF.

CHANGING THE GAS CYLINDER


Take the heater outside and remove the rear panel.

Remove the gas cylinder from the heater and place it on the floor next to the heater.
MAKE SURE THAT THE CYLINDER VALVE IS CLOSED BEFORE ATTEMPTING TO
DISCONNECT THE REGULATOR. Unscrew the regulator clockwise

Before connecting the refilled cylinder, check that the nose seal on the regulator is not
damaged and is still in good condition. If in doubt, take the regulator to an authorised
dealer to be checked.

Screw the regulator anticlockwise
rear of the heater body. Ensuring that it is placed in such a manner that the hose is not
trapped or block in any way.

Fit the retaining panel back on to the body securing the clips on both sides.
MAINTENANCE AND SERVICING INSTRUCTIONS

Ensure that the voltage on the rating label corresponds to the mains voltage in your home.

Check the power cord and plug regularly for any damage. If the cord or the plug is damaged, it must
be replaced by the manufacturer or a qualified person in order to avoid electrical hazard.

Remove the plug from the socket by gripping the plug. Do not pull on the cord to disconnect the
appliance from the mains.

Always unplug the unit when not in use, before cleaning or when adding or removing parts.

Ensure that the cord is not in a position where it can be pulled on inadvertently.

Do not allow the cord to touch hot surfaces.

Use of an extension cord with this appliance is not recommended. However, if it is necessary to use
an extension cord, ensure that the lead is suited to the power consumption of the appliance to avoid
overheating of the extension cord, appliance or plug point. Always unwind the extension cord fully
before use. Do not place the extension cord in a position where it can be pulled on by children or
animals or tripped over.

DO NOT pull or move the appliance by the power cord.

Always unplug the unit when not in use and before cleaning.

Ensure the switch is in the "off" position after each use.

The manufacturer does not accept responsibility for any damage or injury caused by the improper or
incorrect use, or for repairs carried out by unauthorized personnel.
MAINTENANCE AND SERVICING INSTRUCTIONS
There is very little maintenance required on this appliance. Important points to remember are:

Always check that the regulator seal is undamaged when changing the gas cylinder.

Always check that the hose is in good condition before using, and that it is securely
clamped on to the appliance and the regulator.
All manuals and user guides at all-guides.com
at the gas cylinder's control valve.
onto the new cylinder and fit the cylinder into the
.