Russell Hobbs RHG03 Instructions page 4


Before first use it is advisable to check the connection between the gas cylinder and the
regulator for gas leaks as described above.

If there are no gas leaks, place the gas cylinder into the rear of the heater body making sure
that the cylinder is placed in such a manner that the hose is not trapped or blocked in any
way.

Fit the rear retaining panel back onto the body ensuring that it is clipped on to both sides of
the heater.
LIGHTING THE HEATER

The regulator must be securely and fully fastened to the gas cylinder valve.
 To turn the gas ON – carefully open the cylinder valve (anticlockwise
a maximum of one and a half turns.

Turn the heat selection knob on the top panel of the heater to the first
position( 0 )

Push the heat selection knob down and hold it down for 10 seconds. The
gas will flow through the pipe to the heater.

While holding the selector knob down, depress the ignition button
repeatedly until the pilot flame ignites. Panel 1 will start. Release the
ignition button.

The heater is now turned onto Level 1, with one ceramic panel heating.
Select your required heating level by turning the heat selection knob:
( 0 ) : Level 1 – No panel Heating/Off Position
o
: Level 2 – centre panel heating
o ( )
: Level 3 – two panels heating
o ( )
) : Level 4 – three panels heating
o (
All manuals and user guides at all-guides.com
) to