GE Spacemaker DSXH43 Manuel De L'utilisateur Et D'installation page 7

About your dryer features.
CYCLE SIGNAL
O L
FF OUD
WRINKLE CARE
EXTENDED COOL AIR TUMBLE
O O
N FF
Light
cover
Pry with
flat blade
Light
screwdriver
housing
Cycle Signal Option (on some models)
When the signal is on it will sound just
before the end of the cycle to remind
you to remove the clothes. The signal
can be set at OFF (no sound), LOUD or
anywhere in between.
If the dried load cannot be removed
promptly during the EASY CARE cycle,
the Cycle Selector will advance to the
EXTENDED COOL DOWN setting. Unheated
tumbling continues during EXTENDED
COOL DOWN and WRINKLE CARE (on
some models) for 40 minutes to help
reduce wrinkling. When the CYCLE
SIGNAL is on, it will sound briefly every
Wrinkle Care Option (on some models)
Use this option to minimize the wrinkles
in clothes. It provides approximately 15
minutes of no-heat tumbling after the
clothes are dry.
This option can only be used with the EASY
CARE and DELICATES cycles.
Replacing the Dryer Light Bulb (on some models)
WARNING:
risk of electric shock, disconnect this
appliance from the power supply
before attempting any user
maintenance. Turning the controls
to the OFF position does not
disconnect this appliance from the
power supply.
The dryer light is located above the dryer
door opening.
Before replacing the light bulb, be sure to
unplug the dryer power cord or disconnect
the dryer at the household distribution
Drying Rack (on some models)
A handy drying rack may be used for drying
articles such as stuffed toys, pillows or
washable sweaters.
Remove the lint screen.
1
Place the front bar under the lip of the
2
lint screen opening.
When items are dry, remove the rack
3
and replace the lint screen. DO NOT
OPERATE THE DRYER WITHOUT THE LINT
SCREEN IN PLACE UNLESS THE DRYING
RACK IS IN PLACE.
five minutes as a reminder to remove
the load.
NOTE:
I If items are removed before the end of
the cycle, turn the CYCLE SELECTOR knob
to OFF.
I Remove garments promptly at the sound
of the signal. Place clothes on hangers
so wrinkles won't set in.
I Use the Cycle Signal especially when
drying fabrics like polyester knits and
permanent press. These fabrics should
be removed so wrinkles won't set in.
panel by removing the fuse or switching
To reduce the
off the circuit breaker.
To replace the dryer light:
Using a small flat blade screwdriver,
1
pry the bottom of the light cover out
and off the light housing.
Unscrew the bulb when cool and
2
replace it with an appliance bulb of
the same or lower wattage.
Snap the light cover back on the light
3
housing.
NOTE:
I The drying rack must be used with the
TIMED DRY cycle.
I Do not use this drying rack when there
are other clothes in the dryer.
7