Power On & Settings - Bissell 2253 Serie Guide De L'utilisateur

Power On & Settings
WARNING
vacuum is turned on, always move the vacuum via the rolling wheels by using the
upper handle at the back of the vacuum. Do not carry the vacuum while it is running.
Always place vacuum on floor with handle in upright position when using tools.
1
3
TIP: For optimal carpet cleaning performance, adjust to the lowest practical setting. If
your vacuum is difficult to push, adjust to the next higher setting.
Automatic Cord Rewind
1
To plug your vacuum in, gently pull the
cord out of the automatic cord rewind
and stop at the yellow mark on the
cord. Do not pull past the red mark.
Once you have the desired amount of
cord, plug it into the outlet.
NOTE: Rotating Brush Roll continues to rotate while tools are in use. Never place fingers
under the vacuum when it is running. Never place Powerfoot on furniture or uneven
surfaces. Do not place vacuum close enough to objects to pull into rotating brush.
NOTE: Certain carpets and low humidity conditions may generate small static
discharges. Static discharges are harmless and are not associated in any way with the
main power supply.
6
www.BISSELL.com
All manuals and user guides at all-guides.com
To reduce the risk of injury from moving parts while the
Press the red power
button with your
foot to turn the
vacuum ON and
once again to turn
your vacuum OFF
Turn the dial on the foot of the vacuum to the
desired setting. If the dial is difficult to turn, tilt the
vacuum back slightly to take the weight off the foot
while turning.
Lowest setting –
Medium setting – For medium pile carpet.
Highest setting – For high pile and most shag carpet.
2
.
For low pile carpet or bare floors.
To pick up debris, it may be
necessary to move up one setting.
2
When you finish using your vacuum,
unplug it from the outlet. Hold onto
the plug and press the automatic cord
rewind button until it's fully retracted.
If the cord doesn't fully retract on the
first try, pull a little bit of cord out and
press the rewind button again.
Press the Recline
Pedal and pull
handle back
towards you.