Dimplex DWF1326 Manuel Du Propriétaire page 10

Fireplace Installation
mounting holes.
4. Place the bubble level on
the top of the wall-mounting
bracket.
5. Adjust the wall-mounting
bracket so the bubble on the
level is centered between the
two black lines.
6. Mark the three (3) other
mounting screw locations,
on the wall, ensuring that the
wall bracket stays level.
7. Install the supplied wall
anchors on the drywall
marked locations by placing
a Phillips screwdriver into the
recess of the anchor.
8. Press the anchor into the wall
in the desired marked position
while turning the anchor
clockwise until it is flush with
the wall.
9. Insert the wall anchor screws
Figure 4
Screw
Wall
bracket
10
Wall anchor
Figure 5
through the wall bracket and
thread into the wall anchors.
Tighten the screw (Figure 4).
10. Install the remaining screws
through the bracket and into
the wall studs as required.
11. Mount the unit on the wall,
so that the tabs on the wall
bracket have been inserted
into the slots on the back of
the firebox, as shown (Figure
5).
12. Hang the front trim assembly
on the mounts of the firebox
(Figure 6).
13. Excess electrical cord can be
inserted back into the bottom
of the unit, into the cord
storage area.
www.dimplex.com