Assembly - JVC SP-F303 Manuel D'instructions

Assembly

5 Assembling the satellite speakers
Each speaker (except the center speaker) has been divided
into two parts for shipment. Before using this speaker system,
assemble it first by following the procedure below.
• Prepare a Phillips screw driver.
Speaker
section
Before assembling—
• Take care not to drop the stand while assembling;
otherwise, it may cause damage to the floor or injury.
• Ensure enough space for assembly and installation.
• Place a large, thick cloth on the floor where you
assemble the speaker, so you can protect the floor and
the speaker itself.
• Use the speaker only after assembly is fully and
correctly done.
1
Connect the speaker connecters to the
stand connecters.
Speaker connectors
Front
Speaker section
Stand
Front
Stand
Rear
– 2 –
2
Join the stand to the speaker section.
Speaker section
3
Fix the stand to the speaker section.
• Be sure to tighten the screws firmly.
Speaker section
It is recommended to place a cushion under the speaker
section.
• You can tighten the screws easily by placing the
speaker section horizontally.
Cushion (not supplied)
To be continued on the next page
Stand
Stand
Screw (4)
(Supplied, M4 x 25 mm)