Use And Operation - Klarstein 10027129 Mode D'emploi

Way 1
• To install onto the wall drill 4 holes of Ø 8 mm on a suitable place according with the centre dis-
tance of hole in the back of the cooker hood.
• Insert the wall plugs into the holes.
• Insert the screws into the wall pulgs and tight the screws.
• Put up the cooker hood onto the fi xed screws.
• Put the one air outlet and extensible pipe onto the cooker hood. (the extensible pipe is optional
not supplied)
Way 2
• Drill 6 holes of 4mm diameter at the bottom of the hanging cupboard.
• Put the air outlet on the cooker hood, then install the cooker hood on the bottom of the cupboard,
tighten the hood with enclosed 6 screws.
• Install the adjusted board on the bottom of the hood in order to keep out the gap between hood
back and cupboard.
1. Connect the plug into the power.
2. 2Push the switch (1) to turn the lamp
the lamp off .
3. Push the switch (2), to select the speed of the motor in 3 Steps:
I (low) - O (off ) - II (high).
4. The cooker hood will working at low or high speed when pull out
the front panel..
7
All manuals and user guides at all-guides.com

Use and Operation

on. Push into O to put