Samsung HT-E6730W Mode D'emploi page 34

Settings
K
Wireless (General) - Automatic
After following Steps 1 to 3 in "Configuring Your
Network Connection" on page 32:
1 . Select Start in the Network Settings screen,
and then press the E button.
The product searches for and then displays a
list of the available networks.
Network Settings
Select your wireless router from the list:
iptime23
ELT
JSY
KT_WLAN_C361
Mirhenge_edu
SO070VOIP
2 . Select the desired network, and then press
the E button.
3 . Select Next, and then press the E button
again.
4 . On the Security screen, enter your network's
Security Code or Pass Phrase.
Enter numbers directly using the number
buttons on your remote control. Enter letters
by selecting a letter with an arrow button, and
then pressing E button.
5 . When done, select Next at the right of the
screen. The product verifies the network
connection and then connects to the
network.
| NOTE |
\ You should be able to find the Security Code or Pass
Phrase on one of the set up screens you used to set up
your router or modem.
K
Wireless (General) - Manual
If you have a static IP address or the Automatic
procedure does not work, you'll need to set the
Network Settings values manually.
After folloiwng Steps 1 to 3 in "Configuring Your
Network Connection" on page 32:
34
|
English
HT-E6730W_ZC_0314.indd 34 HT-E6730W_ZC_0314.indd 34
All manuals and user guides at all-guides.com
1 . Select Start in the Network Settings screen,
2 . Select the desired network or Add Network,
3 . Select Next, and then press the E button
4 . If you selected a network in Step 2, go to
1/10
5 . Enter your wireless network or wireless
Refresh
WPS(PBC)
Previous
Next
Cancel
6 . Select the Security Type, select Next, and
7 . On the Security screen, enter your network's
8 . When done, select Next at the right of the
9 . The Network Status screen appears.
10 . Select IP Settings on the right of the screen,
and then press the E button. The product
searches for and then displays a list of the
available networks.
and then press the E button.
again.
Step 7. If you selected Add Network, go to
Step 5.
router's name.
• Enter numbers directly using the number
buttons on your remote control.
• Enter letters by selecting a letter with the
▲▼◄► buttons, and then pressing the
E button.
• To display capital letters (or redisplay small
letters if capital letters are displayed), select
A/a, and then press the E button.
• To display symbols and punctuation, select
, and then press the E button. To
redisplay letters, select , and then press
the E button.
When done, select Next, and then press the
E button.
then press the E button.
Security Code or Pass Phrase.
• Enter numbers directly using the number
buttons on your remote control.
• Enter letters by selecting a letter with the
▲▼◄► buttons, and then pressing the
E button.
screen, and then press the E button.
The product attempts to verify the network
connection and fails.
and press the E button. The IP Settings
screen appears.
2012-03-14 오후 3:48:43 2012-03-14 오후 3:48:43