Maintenance; Removing The Cleaner From The Pool - Pentair PROWLER 917 Guide D'installation

Make sure the cleaner' s power supply
is turned "OFF" and is disconnected
from the electrical source/outlet before removing the
cleaner from the pool. Moving parts may injure hands
or fingers if cleaner inadvertently powers on during
servicing.

Removing the Cleaner from the Pool

The cleaner will shut off automatically at the end of a
cleaning cycle. Follow the steps below to remove the
cleaner from the pool.
Ensure the power supply is turned "OFF"
and disconnected from the electrical
source/outlet before removing the cleaner from the
pool. Operating the cleaner out of water will immediately
cause severe damage and will result in loss of warranty.
Do not leave the cleaner in the pool all the time.

MAINTENANCE

1. Disconnect the power supply cable from the
electrical outlet and disconnect the cleaner
communication cable from the power supply.
2. Using the communication cable, slowly and gently
pull the cleaner to the waterline at the edge of the
pool until you can reach the handle. DO NOT lift the
cleaner out of the water by the cable.
3. Using the handle, lift the cleaner out of the pool.
See Figure 7.
Note: Never lift the cleaner out of the pool by the
communication cable. This puts an unnecessary
strain on the cable and could result in damage to
the cleaner.
4. Place the cleaner on the edge of the pool and allow
excess water to drain from the cleaner body and
basket.
5. Disconnect the communication cable from the
power supply.
6. Store the cleaner in a covered area with the
communication cable coiled.
PROWLER 917 Robotic Inground Pool Cleaner Installation and User' s Guide
™
Figure 7
5