Cleaning The Impeller - Pentair PROWLER 917 Guide D'installation

8

Cleaning the Impeller

Always disconnect power to the cleaner before servicing, disassembly, or reassembly. Failure to
do so could result in death or serious .
Every so often debris may become trapped in the Prowler™ 917 Robotic Pool Cleaner' s impeller. To clean out debris
trapped in the impeller opening, follow the instructions below.
STEP 1:
Open the Filter Cover and Remove the Basket
See Figure 17 and 18.
Figure 17
STEP 2:
Remove Debris from Impeller Cover
By hand, clean as much debris as possible from the
opening of the cleaner' s impeller. See Figure 19.
Sometimes the debris may become lodged deeper in the
impeller where you can not reach it. If this is the case,
proceed to the next step to remove the impeller cover.
Figure 19
PROWLER 917 Robotic Inground Pool Cleaner Installation and User' s Guide
™
MAINTENANCE
STEP 3:
Unmount the Impeller Cover
Using a No. 2 Phillips-head screwdriver, remove the
two screws that hold the impeller cover in place. These
screws can be found in the bottom corners of the
impeller cover. See Figure 20.
Place the two screws to the side.
Figure 18
STEP 4:
Remove the Impeller Cover
Gently pull the impeller cover away from the cleaner
body. See Figure 21.
By hand, remove any debris that has become trapped
around the impeller.
Remount the impeller cover with two impeller cover
screws.
Figure 20
Figure 21