Pentair PROWLER 917 Guide D'installation page 7

PREPARATION OF THE POOL AND CLEANER
STEP 4:
Connect Power Supply to Power Source
Connect the power supply to the electrical source/outlet.
See Figure 4.
RISK OF ELECTRICAL SHOCK OR
ELECTROCUTION: Connect only to a
grounding type receptacle protected by a earth leakage
circuit breaker 30mA. Contact a qualified electrician if
you cannot verify that the receptacle is protected by a
earth leakage circuit breaker 30mA.
To reduce the risk of electrical shock,
do not use extension cord to connect
unit to electrical supply; provide a properly located outlet.
Figure 4
STEP 5:
Placing the Cleaner in the Pool
the pool cleaner to "ON". Operating the cleaner out of
water will immediately cause severe damage and will
result in loss of warranty. Do not leave the cleaner in
the pool all the time. Always remember to turn the power
supply "OFF" and unplug it from the power outlet before
removing the cleaner from the pool.
1. Be sure the power supply is positioned a minimum
of 3.5 m from the pool.
2. Lower the cleaner into the pool by the handle.see
Figure 5.
Note: Never lower the cleaner into the pool by the
communication cable. This puts an unnecessary
strain on the cable and could result in damage to
the cleaner.
3. Gently tilt the cleaner from side to side or turn
upside down to release trapped air. See Figure 6.
4. Once the cleaner is resting flat on the pool floor,
continue to the next page for instructions on either
manually starting the cleaner or setting a weekly
schedule.
PROWLER 917 Robotic Inground Pool Cleaner Installation and User' s Guide
™
ALWAYS ensure the cleaner is fully
immersed in water before switching
Figure 5
3
Figure 6