Operation; Manually Starting The Cleaner; Setting A Weekly Schedule; Choosing A Style Of Filter Screen - Pentair PROWLER 917 Guide D'installation

4
ALWAYS ensure the cleaner is fully immersed in water before manually starting the cleaner or
before setting a weekly schedule. Moving parts may injure hands or fingers and operating the
cleaner out of water will immediately cause severe damage to the cleaner.
Do not operate the cleaner when there are people swimming in the pool. Communication cable
can trip or entangle swimmers which could result in drowning.

Manually Starting the Cleaner

To manually start a cleaning cycle, ensure the cleaner is fully immersed in water and press the power supply' s ON/
OFF button. The cleaner will run a two hours cleaning cycle and then automatically shut off.
To stop an active cleaning cycle, press the ON/OFF button while the cleaner is running.

Setting a Weekly Schedule

An automatic cleaning schedule may be set at the power
supply each week. Ensure the cleaner is fully immersed
in water before setting a weekly schedule, as the cleaner
will always start when a weekly schedule is set.
ON/OFF
Button

Choosing a Style of Filter Screen

The Prowler™ 917 Robotic Pool Cleaner offers two styles of debris filtration. The filter basket is shipped with two
mesh filter screens and two pleated screens installed. Two additional pleated screens are provided with the cleaner
and are interchangable with the mesh filter screens.
Cleaner performance can be improved by using certain filter screens in certain situations and pool environments:
Factory-installed mesh filter screens should be used when vacuuming larger debris from the pool. Larger debris
is common when first opening a pool or after a strong storm.
Ultra-fine pleated filter screens should be used in most situations, when vacuuming smaller debris.
Both styles of filter screen are removed from and installed into the filter basket similarly. To remove and install filter
screens, follow the appropriate instructions given in Periodic Filter Screen Cleaning on page 6.
PROWLER 917 Robotic Inground Pool Cleaner Installation and User' s Guide
™

OPERATION

3 Schedule
LEDs
Weekly Schedule
Button
When the power supply is switched on, a cleaning
schedule for the coming week is set by pressing the
Weekly Schedule button as instructed below:
LED 1 - Cleaner will run a two hour cleaning cycle
every day (7 times per week). Press the Weekly
Schedule button once to select this interval.
LED 2 - Cleaner will run two hour cleaning cycle every
other day (3 times per week). Press the Weekly
Schedule button twice to select this interval.
LED 3 - Cleaner will run a two hour cycle every 3 days
(2 times a week). Press the Weekly Schedule
button three times to select this interval.
To reset a weekly schedule, press the Weekly Schedule
button four consecutive times. If you do not press any
of the buttons within the first 5 seconds after the power
has been switched on, the cleaner will default to manual
operation.
While the cleaner is in weekly schedule mode, the
appropriate Schedule LED will blink between cycles.
At the end of the week the power supply automatically
shuts off.