Koenic KWM 62212 A3 Mode D'emploi page 21

Installation
Note:
The washing machine is equipped with
power cord and plug and needs sewage and
tap water connection. Before installation,
make sure that the wall outlet is at the
desired place of installation.
Consider the dimension (chapter Technical
data) of the product for placing and
installation.
Caution
• Before initial operation the transport
restraints must be removed from the
backside of the unit. Operating the
washing machine with mounted transport
restraints leads to serious damages.
• Keep the transport restraints for later
use. Never transport the device without
correctly mounted transport restraints!
Fig. Loosen the four transport restraints
1
with a wrench (13 mm) and unscrew
them completely. Insert the 4 supplied
blind plugs in the holes.
Fig. Place the washing machine on an even,
2
horizontal and steady surface. For
levelling, the feet are adjustable and can
be screwed in or out.
• If the feet cannot be loosened by
hand, use pliers.
• Turn the feet to the right to screw
them in and to the left to unscrew
them.
• Use a spirit level to check whether
the appliance is levelled. If the
appliance is not standing horizontally
or is tilting, the feet must be adjusted
again.
• If the unit is levelled and does not
tilt, tighten the nuts with an open-
end wrench.
IM_KWM62212-A3_191107_V09_HR.indb 21
All manuals and user guides at all-guides.com
Note:
Note the following, when placing the
appliance on a platform:
The appliance might move during spinning
and could fall of a platform. To prevent this,
the feet must be secured with retaining tabs
(available in specialized stores).
The washing machine must be
Fig.
3
connected to a drain.
• The drain hose is already fixed to the
sewage connection. Pull the hose out
of the clamps and unwind it.
• Connect the other end to the drain
pipe (option A or B). Observe the max.
height of the hose end.
Note:
• To avoid leakage, a hose clamp should be
used to correctly install the outlet hose.
• Suitable hose holders are available as
optional accessories.
Connect the water inlet to the water
Fig.
4
system (3/4 ") using the supplied
hose and make sure that everything
is connected correctly and firmly. The
water pressure must be between
0.05 MPa and 1 MPa. A pressure
reducing valve must be used if the
water pressure exceeds 1 MPa. The
correct installation of the water
connection should be checked on a
regular basis.
Note:
• If the water pipes are new or have not
been used for an extended period of time,
allow a certain amount of water to drain
until you are sure that the water is clear
and free of foreign objects.
• If this point is not observed, there is a risk
that the water inlet will become clogged
and the unit will be damaged.
Plug the mains plug into a suitable
Fig.
5
socket.
English
21
8/11/2019 10:11