Best CC6 Serie Guide D'installation page 7

7. UNPLUG THE BLOWER(S)
Unplug the blower(s) (one or two, depending on model) from the front panel.
8. REMOVE WIRING COVER AND FRONT PANEL
Using a Robertson or a Phillips no. 2 screwdriver, remove both wiring cover retaining screws (A).
Detach it from the power pack and set aside with its screws. Then, remove both sides screws (B)
retaining the front panel to the power pack. Carefully detach the front panel from the power
pack and set aside with its screws.
9. REMOVE THE ELECTRICAL KNOCKOUT
From inside the power pack, punch out the electrical knockout hole on top right side (C) OR
on back right side (D). Install the wire clamp (included in parts bag).
10. REMOVE THE KNOCKOUT OPENING (
Remove the knockout opening on top (vertical
discharge installation) or on back (horizontal
discharge installation) of the power pack.
SINGLE BLOWER MODEL ONLY
1
HR0037
7
HE0105
B
HD1098
HR0030
)
2
A
C
D