Led Lighting - Best CC6 Serie Guide D'installation

19. REINSTALL FILTERS
Remove protective plastic film covering filters before installing them.
1. Using a Phillips no. 2 screwdriver, assemble the knob to each filter.
NOTE: The screw MUST BE on filter tabs side. See illustration at right.
2. Rest rear filters edge on filter springs (A) in the power pack.
3. Using knob, tilt up the filters into position. Make sure filter tabs (B) are securely engaged in
power pack front edge after installation.

20. LED LIGHTING

The lighting of this unit is produced by two LED modules (included).
Do not touch lamps during or soon after operation. Burns may occur. Cannot be replaced by any other type of light
bulb or LED module.
21. USE AND CARE
Filters
The filters should be cleaned frequently. Use a warm detergent solution. Wash more often if your cooking style generates more grease —
like frying foods or wok cooking.
Remove filter by pushing it towards the back of power pack and rotating filter downward. Filters are dishwasher safe. Allow filters to dry
completely before reinstalling them in the power pack.
Clean all-metal filters in the dishwasher using a non-phosphate detergent. Discoloration of the filters may occur if using phosphate de-
tergent or as a result of local water conditions — but this will not affect filter performance. This discoloration is not covered by the warranty.
Power Pack Cleaning
Stainless steel cleaning:
Do:
• Regularly wash with clean cloth or rag soaked with warm water
and mild soap or liquid dish detergent.
• Always clean in the direction of original polish lines.
• Always rinse well with clear water (2 or 3 times) after cleaning.
Wipe dry completely.
• You may also use a specialized household stainless steel
cleaner.
Avoid when choosing a detergent:
- Any cleaners that contain bleach will attack stainless steel.
- Any products containing: chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly.
- Any combustible products used for cleaning such as acetone, alcohol, ether, benzol, etc., are highly explosive and should never be
used close to a range.
CAUTION
WARNING
!
Don't:
• Use any steel or stainless steel wool or any other scrapers to
remove stubborn dirt.
• Use any harsh or abrasive cleansers.
• Allow dirt to accumulate.
• Let plaster dust or any other construction residues reach the
power pack. During construction or renovation, cover the power
pack to make sure no dust adheres to stainless steel surface.
12
HO0139
A
B
HD0373