Velleman CAMIP16 Guide D'installation Rapide page 6

DO NOT use this product to violate privacy laws or perform other illegal
activities.
4. Overview
Refer to the illustrations on page 2 of this manual.
1 lens
2 sun shield
3 bracket
4 position bolt
5 bracket screw holes
6 joint
7 camera screw holes
8 camera front cover
9 focal length screw
10 focus screw
11 desiccant
12 sun shield installation
13 microSD card
14 PC
15 PoE router/hub
5. Installation
1. Choose a location for the camera, keeping following guidelines in mind:
o Do not install the camera in locations where extremely high or low
temperatures or excessive vibrations may occur.
o Avoid mounting the camera near high electro-magnetic fields.
o Do not aim the camera at the sun or other extremely bright objects
or reflections (e.g. metal doors).
2. Use the mounting bracket [3] to determine the location of the
mounting holes. Drill the holes and secure the bracket using
3 screws [5].
3. Remove the joint [6] from the bracket.
4. Connect the joint to the back of the camera.
Note: There are two screw holes [7] for the joint on the back of the
camera. Choose the one that best suits your installation location.
5. Re-attach the joint (with the camera) to the mounting bracket.
6. Point the camera towards the field of interest and tighten the position
bolt [4].
V. 01 – 13/06/2013
CAMIP16
16 8P8C network cable
17 8P8C network cable
18 power
19 PC
20 non-PoE router/hub
21 8P8C network cable
22 PoE injector
23 8P8C network cable
24 power
25 NVR
26 LAN SWITCH connector
27 8P8C network cable
28 router/hub
29 8P8C network cable
30 cameras
6 ©Velleman nv