Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
MaxLite LED FLAT PANEL RETROFIT KIT (1x4, 2x2, & 2x4)
®
Installation & Operation
1. Drill two holes on the housing using self tapping
screws and attach the safety cables. Apply
relamping label to housing where it will be visible
after installation. (Fig. 1)
3. Open the J-box and make your wiring connections
while the panel hangs from the 2 safety cables. (Fig. 3)
4. Make wiring
connections
according to
wiring diagrams.
(Fig. 4)
© Copyright 2019. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
+
0-10V
OUTPUT +
-
N
WHITE
OUTPUT -
DRIVER
L
BLACK
Standard Wiring Diagram
(No microwave sensor)
UNSWITCHED HOT
WALL SWITCH
COMMON
BLACK
L
WHITE
L'
SENSOR
N'
-
0-10V
+
+
0-10V
OUTPUT +
-
WHITE
N
OUTPUT -
DRIVER
L
BLACK
2. Use 1 of the bracket pieces and place it under the
housing and T-grid on the side with safety cables. (Fig. 2)
PANEL
BLACK
WHT/BLUE
Emergency Backup Driver With
Microwave Sensor Wiring Diagram
WHITE
WHT/RED
BLUE
ORANGE
YELLOW
LED -
LED +
PANEL
FPR Series
L
BLACK
WHITE
L'
SENSOR
N'
-
0-10V
+
+
0-10V
-
OUTPUT +
DRIVER
WHITE
N
OUTPUT -
BLACK
Microwave Sensor
Wiring Diagram
PANEL
Page: 3
REV: 3/27/19
Publicité
Table des Matières
