Printer Test; Maintenance; Changing Paper; Replacing The Ribbon - Mettler Toledo BT-P42 Mode D'emploi

4

Printer test

5

Maintenance

Under normal ambient conditions, the BT-P42 Printer requires practically no maintenance thanks to
its rugged construction. The METTLER TOLEDO service department is available should servicing be
required. Please ask your responsible METTLER TOLEDO dealer for details.
5.1

Changing paper

Insertion of a new roll of paper is described at item 2.4. Order number for paper, see item 7.
5.2

Replacing the ribbon

1
4
3
2
6
5
6 BT-P42 Printer
The BT-P42 is equipped with a self-test which automatically
prints out the character set of the printer.
Starting the test
• Switch on BT-P42 and at the same time press and hold
a few seconds.
Terminating the test
• Switch off the BT-P42.
• Pull paper out of printing unit (1).
• Remove ribbon cover (2, 3, 4).
• To remove ribbon cartridge, press in direction of arrow (5).
• Insert new ribbon and if need be, take up slack with tension-
ing wheel (6).
• Refit ribbon cover.
• Insert paper and feed through slit in the printing unit as far as
it will go.
• Press and hold until sufficient paper has been fed in.
for